![]() ![]() roles were exactly as specified by Agilent for the Chemstation. I would completely uninstall all programs and then double check these and then re-install. The problem remains even when I remove the HP82340/82341 interface from the. Also the subnet and gateways must be identical on the machines. Order doesn't matter but they should all share the same number sequence. ![]() If your computer IP address is 10.0.1.101 then the GC should be 10.0.1.102 and MS should be 10.0.1.103 etc. Also, make sure GC and MS are all plugged into the network hub (little HP box with ethernet ports) and make sure that all your IP addresses are set correctly with the same subnets on all instruments and the computer itself. I have had problems with specific "services" in windows either not being ON or OFF on various computers while upgrading to E.02. They have helped me many times in the past. ![]() They should help you with the installation over the phone for free. » application agilent gc » cfvceyu gc cm.n » openlab cds gc chemstation upgrade » ibm gc analysis tool » fkrfntkm gc cm. Should get to Product support and it will ask you to type in the 4 digit product code (1701 for MSD Chemstation I believe). Then, edit the lines for devices and instruments in the main PCSsection to read: devices instruments. Try calling Agilent's service number:Ĩ00–227–9770 then select options 3-3-1-2 or something to that effect. To do this, edit the CHEMSTATION.INIfile using the NOTEPAD editor and remove the sections that are preceded by PCS,1, PCS,2, PCS,3,and PCS,4, including the section titles. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |